Mitsubishi Electronics MDS-D-SPJ3 Engraver User Manual


 
Appendix 4 - 1
付録
Appendix 4
Appendix 4 - 1
Contents
Appendix 4
EMC Installation Guidelines
Appendix 4-1 Introduction ................................................................... Appendix 4 - 2
Appendix 4-2 EMC instructions........................................................... Appendix 4 - 2
Appendix 4-3 EMC measures ............................................................. Appendix 4 - 3
Appendix 4-4 Measures for panel structure ........................................ Appendix 4 - 3
Appendix 4-4-1 Measures for control panel unit ............................ Appendix 4 - 3
Appendix 4-4-2 Measures for door ................................................ Appendix 4 - 4
Appendix 4-4-3 Measures for operation board panel..................... Appendix 4 - 4
Appendix 4-4-4 Shielding of the power supply input section.......... Appendix 4 - 4
Appendix 4-5 Measures for various cables......................................... Appendix 4 - 5
Appendix 4-5-1 Measures for wiring in panel................................. Appendix 4 - 5
Appendix 4-5-2 Measures for shield treatment .............................. Appendix 4 - 5
Appendix 4-5-3 Servo/spindle motor power cable ......................... Appendix 4 - 6
Appendix 4-5-4 Servo/spindle motor feedback cable..................... Appendix 4 - 7
Appendix 4-6 EMC countermeasure parts.......................................... Appendix 4 - 8
Appendix 4-6-1 Shield clamp fitting................................................ Appendix 4 - 8
Appendix 4-6-2 Ferrite core ........................................................... Appendix 4 - 9
Appendix 4-6-3 Power line filter ................................................... Appendix 4 - 10
Appendix 4-6-4 Surge protector................................................... Appendix 4 - 16