Filter
Top Products
5 - 43
MDS-D-SVJ3/SPJ3 Series Specifications Manual
5-4 Drive unit option
< R-UNIT-5 >
[Unit: mm]
Type
Regenerative
capacity (W)
Resistance
value ( )
Mass (kg)
R-UNIT-5 3100 10 15.0
2. Attach packing to the flange section.
3. Do not wire or arrange other devices in front of the section marked with a as extremely hot wind
will be blown out.
4. For the installation direction of this resistor, the "Ceiling" is the top and "Ground" is the bottom.
5. Touching the resistor when it is hot could lead to burns. Always install a protective cover or
consider the installation site so that workers will not touch the unit.
6. The resistor's heating value will differ according to the acceleration/deceleration frequency, speed
being used and the load GD
2
conditions, etc. However, install the resistor so that the hot wind is
always exhausted to outside the panel.
7.5
3607.5
375
1.61812012018
276
23 20 140 23
255
75 75 98
340
22
160
6
91
29
3-Φ6
TE1
4
4
#.
#.
#%
#%
E
259
6-M5 x 0.8
345
360
120 120
R1
R2
AL1
AL2
AC1
AC2
E
Punch
hole
Suction
screw
Embedded installation
(Installation hole dimensions)
-4
l:
Terminal screw size:
M4 x 0.7 screw
Applicable crimp termina
Bare round terminal up to 5.5
Terminal layout
(Earth terminal)
Hot wind discharge
Ceiling
Ground
Embedded installation
(outer heat radiating section)
hole
Power for fan
AC200V, 50/60Hz
32/30W, 0.21/0.19A
CAUTION