Filter
Top Products
For Machines Mfg. Since 7/09 Model SB1016/SB1036
-17-
PREPARATION
— If one or more pump motors do not pump
or rotate in the incorrect direction, locate
the master power switch on the lathe,
and swap any two of the L1, L2, or L3
incoming power leads shown in Figure 4.
Ground
Hot
Hot
Hot
DISCONNECT
SWITCH
(as recommended
)
L3
L2L1
MASTER
POWER SWITCH
L3
L3
L2
L2
L1
L1
1
2
3
5
6
4
Figure 4. Machine incoming power supply wires.
Swap any
Two of
These Wires
2. Close the electrical cabinet door, reinstall
motor covers and access panels, and test
machine operation.
Figure 5. Component locations in lathe electrical
cabinet.
Variable Frequency
Drive (Figure 3)
Master Power
Switch (Figure 4)