Filter
Top Products
For Machines Mfg. Since 7/09 Model SB1016/SB1036
-33-
OPERATION
K. Cutting Fluid Pump Switch: Start/stops the
cutting fluid pump motor.
L. Jog Button: Turns the spindle motor ON
while being pressed and held.
M. Stop Button: Stops all machine functions.
Twist clockwise to reset.
N. Carriage Handwheel: Moves the carriage
parallel along the ways, and can be
disengaged when power feed operations
would make it an entanglement hazard.
O. Cross Slide Handwheel: Moves the cross
slide perpendicular to the ways into the
workpiece.
P. Compound Slide Handwheel: Moves the tool
in fine increments at compound angles.
Q . 4-Position Tool Post Lever: Locks the rotary
tool post in four possible detents.
R. Flow Control Lever: Controls the flow of
cutting fluid from the nozzle.
Carriage Controls
N
P
Figure 40. Carriage controls.
O
Q
T
U
R
S
W
V
Y
Z
X
S. Way Oil Oil Pump: Draws oil from the apron
case and lubricates the carriage and ways
through various oil ports.
T. Carriage Lock: Secures the carriage in place
for greater rigidity and accuracy when
using the cross or compound slide for the
machining operation.
U. Thread Dial and Chart: Dial indicates when
to engage the half nut during threading
operations. Chart indicates on which thread
dial reading to engage the half nut for
specific inch or Whitworth thread pitches.
V. Feed ON/OFF Lever: Engages and
disengages the longitudinal and cross feed
system at the apron.
W. Half Nut Lever: Engages and disengages the
half nut for threading operations.
X. Spindle ON/OFF Lever: Starts, stops and
reverses direction of spindle rotation.
Y. Apron Feed Direction Knob: Changes
direction of carriage feed or the cross slide
feed without having to stop the lathe and
move the headstock feed direction lever.
Z. Feed Selection Knob: Selects either the
carriage feed or the cross slide feed.
AA. Feed Clutch: This adjustable clutch helps
protect the feed system against broken gears
and shafts caused by accidental overloads.
Figure 41. Adjustable feed clutch.
AA