Filter
Top Products
-82-
For Machines Mfg. Since 7/09
Model SB1016/SB1036
SERVICE
Brake Inspection &
Replacement
The linkage geometry on this lathe is non
adjustable. Before replacing the brake shoes,
verify that all fasteners are tight, and all clevis
pins and yokes have minimal wear. As pivot
points wear, the increased slop in the linkage
absorbs the usable stroke that is required for full
brake application. If the brake does not stop the
lathe as fast as it should, before replacing the
brake shoes, verify that the linkage is not worn
and is the cause of the problem.
Tools Needed: Qty
Another Person ....................................................1
Hex Wrench 6mm .................................................1
Hex Wrench 8mm .................................................1
Needle-Nose Pliers ................................................1
Basic Caliper ........................................................1
Safety Glasses ......................................................1
Respirator Rated for Brake Dust ........................1
To replace the brake shoes:
1. DISCONNECT LATHE FROM POWER!
2. Put on a respirator and eye protection to
protect yourself from hazardous brake dust.
3. With the help of another person, remove the
splash guard, which is attached with the five
capscrews shown in Figure 147.
4. Once the splash guard is removed, remove
the two chuck guard mount cap screws
(Figure 147) and the chuck guard from the
headstock cover.
Figure 147. Tailstock end splash guard fasteners.
Splash
Guard
Chuck Guard
Headstock
Cover
Chuck
Guard