Filter
Top Products
-70-
For Machines Mfg. Since 7/09
Model SB1016/SB1036
MAINTENANCE
Apron
Oil Type ......Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ............................................ As Needed
Check/Add Frequency ....................................Daily
Change Frequency ...................................Annually
Checking & Adding Oil
The sight glass shown in Figure 124 shows
the oil level in the apron. At the full level, the
oil fills approximately
3
⁄4 of the sight glass. At
the add level, the oil fills
1
⁄4 of the sight glass or
less. Check the oil level daily and after using the
apron oil pump.
Changing Oil
The oil in the apron reservoir must be changed
after the break-in period and then annually (or
every six months with hard service or extreme
working conditions). The drain plug is shown in
Figure 124 is removed with a 6mm hex wrench,
and the knurled fill plug is shown in Figure
125 is removed by hand.
Figure 125. Location of fill plug for apron oil reservoir.
Fill Plug
Figure 124. Location of apron drain plug & sight glass.
Drain Plug
Sight Glass
Ways & Slides
The way pump shown in Figure 126 lubricates
the saddle and cross slide way guides with the oil
from the apron reservoir.
Figure 126. Location of way pump and sight glass.
Sight Glass
Fill Plug
Way
Pump
Lead Screw
Oil Type ......Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ............................................ As Needed
Lubrication Frequency ...................................Daily
Before lubricating the leadscrew, clean it first
with mineral spirits. A paint brush works well
to help clean out the threads. Make sure to move
the carriage out of the way, so you can clean the
entire length of the leadscrew.
Apply a thin coat of oil along the length of the
leadscrew. Use a paint brush to make sure the
oil is evenly applied and down in the threads.
To use the way pump to lubricate the ways, pull
the pump knob out for two or three seconds and
then push it in. The pump draws oil from the
apron reservoir and then forces it through drilled
passages to the way guides.
Repeat this process and move the carriage left/
right and the cross slide forward/backward to
distribute oil along the way guides.
Lubricate the guides once before and once after
operating the lathe. If the lathe is in a moist
or dirty environment, increase the lubrication
interval and make sure to keep the oil level full.