Filter
Top Products
-86-
For Machines Mfg. Since 7/09
Model SB1016/SB1036
SERVICE
10. With the pin completely seated in the bore
and the head flush with the leadscrew
shoulder, slide the shroud washer against
the shoulder, and rotate it 180° (see Figure
158) to cover the shear pin.
Figure 157. New shear pin installed in bore.
New Pin
8. Blow out the shear pin hole with compressed
air, and put a drop of oil in the hole.
9. Insert the new shear pin into the bore, as
shown in Figure 157. If the pin does not
freely slide into the bore, DO NOT hammer
on the pin or you will mushroom the shear
pin head, preventing installation. Instead,
file a slight chamfer on the end of the pin to
make it easier to align and insert.
7. Use the magnet to remove the shear pin
head, then rotate the lathe spindle by hand
to line up the inner and outer bores, as
shown in Figure 156. Next, use the magnet
to remove the other half of the broken shear
pin when it becomes visible.
Figure 156. Aligned shear pin bores.
Outer Bore
Inner Bore
11. Slide the retaining ring against the shroud
washer, so the retaining-ring ears are offset
from the hole in the shroud washer, as
shown in Figure 159.
Figure 158. Rotating washer to cover shear pin.
Rotate
Washer
180°
Figure 159. Offset positioning of retaining ring ears
and hole in shroud washer.
Retaining
Ring Ears