Toshiba e-Studio200 Work Light User Manual


 
e-STUDIO160/200/250 GENERAL PRECAUTIONS December 2002 TOSHIBA TEC
Avoid exposure to laser radiation during servicing.
Avoid direct exposure to beam.
Do not insert tools, parts, etc. that are reflective into the path of the laser beam.
Remove all watches, rings, bracelets, etc. that are reflective.
4. Main Service Parts for Safety
The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly important
for safety. Be sure to handle/install them properly.
5. Cautionary Labels
During servicing, be sure to check the rating plate and the cautionary labels such as “Unplug the
power cord during service”, “Hot area”, “Laser warning label” etc. to see if there is any dirt on their
surface and whether they are properly stuck to the copier.
6. Disposition of Consumable Parts/Packing Materials
Regarding the recovery and disposal of the copier, supplies, consumable parts and packingm a -
terials, it is recommended to follow the relevant local regulations or rules.
7. When parts are disassembled, reassembly is basically the reverse of disas-
sembly unless otherwise noted in this manual or other related documents. Be
careful not to reassemble small parts such as screws, washers, pins, E-rings,
toothed washers in the wrong places.
8. Basically, the machine should not be operated with any parts removed or dis-
assembled.
9. Precautions Against Static Electricity
The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband,
because the ICs on it may become damaged due to static electricity.
Caution: Before using the wrist band, pull out the power cord plug of the copier and make
sure that there is no uninsulated charged objects in the vicinity.
Caution: Dispose of used batteries and RAM-ICs including lithium batteries according to the
manufacturer's instructions.
Attention: Se débarrasser de batteries et RAM-ICs usés y compris les batteries en lithium
selon les instructions du fabricant.
Vorsicht: Entsorgung des gebrauchten Batterien und RAM-ICs (inklusive der Lithium-Batterie)
nach Angaben des Herstellers.