Filter
Top Products
e-STUDIO160/200/250 ADJUSTMENT ITEMS 1 - 86 December 2002 TOSHIBA TEC
1.9 Adjusting the main drive gear
assembly
1. Loosen 2 screws (A) retaining the backlash ad-
justing gear of the main drive gear assembly.
2. Locate the main drive gear assembly in the
copier and temporarily tighten 7 screws (B).
Fig. 1-9-1
3. Loosen one screw and remove the bushing
plate.
Fig. 1-9-2
4. Place the drive gear jig by aligning with the drum
shaft and the process unit positioning stud.
Fig. 1-9-3
5. Loosen the wing screw and hold the drive gear
jig arm to the registration roller.
6. Place the tab of the drive gear jig arm in the
hole and tighten the wing screw.
Fig. 1-9-4
01
02
03
04
2 screws (A)
Main drive gear assembly
Screw (B)
Screw (B)
Bushing plate
Process unit
positioning stud
Drive gear jig
Drum shaft
Wing screw
Registration roller
Drive gear jig arm
Tab