Filter
Top Products
Prestige 791R G.SHDSL Router
NAT 27-3
Menu 15 — NAT Setup
1. Address Mapping Sets
2. NAT Server Sets
Enter Menu Selection Number:
Table 27-1 Applying NAT to the Remote Node
FIELD DESCRIPTION EXAMPLE
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige. The SMT
uses the address mapping set that you configure and enter in the
Address Mapping Set field (menu 15.1 - see section 27.3.1).
Full Feature
Select None to disable NAT. None
NAT
When you select SUA Only, the SMT uses Address Mapping Set 255
(menu 15.1 - see section 27.3.1). Choose SUA Only if you have just
one public WAN IP address for your Prestige.
SUA Only
27.3 NAT Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the
SMT will use Set 1, which supports all mapping types. When you select SUA Only, the SMT will use the
pre-configured Set 255 (read only).
The Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the
Prestige 10), a server rule must be set up inside the NAT Address Mapping set. To configure NAT, enter 15
from the main menu to bring up the following screen.
Figure 27-3 NAT Setup
27.3.1 Address Mapping Sets
Enter 1 to bring up Menu 15.1 — Address Mapping Sets.