Top Page > Getting Started > Entering Characters > Fax Number Input Mode
Fax Number Input Mode
Fax number input mode becomes active when entering fax numbers. In this mode, use the keys as follows:
● To enter a number
Press a number key.
● To enter characters other than digits
“
”: Press the [ ] key.
“
”: Press the [ ] key.
“+”: Press [0] twice.
Pause: Press the [Pause/Redial] key. A pause is indicated on the screen as a “P”.
Space: Place the cursor on the right-most character, and then press the [
] key.
● To move the cursor left or right
Press the [
] key to move the cursor left, and the [ ] key to move the cursor right.
If you enter a character when there is a character at the cursor position, the current character shifts
to the right.
● To delete a character
Place the cursor on the character you want to delete, and then press and hold the [
] key until the
character is deleted.
● To delete all characters
Press the [Clear/Stop] key.
● Some characters other than digits cannot be used, depending on the setting you are configuring.
● When the maximum number of characters has already been entered, characters entered subsequently are ignored.
Top Previous Next
Copyright © 2009
Contents Previous Next Settings
