Top Page > Configuring the Machine Using the Control Panel > Network Settings > Network Setting Parameters
Network Setting Parameters
This section describes the network setting parameters.
Ethernet
● MAC
Displays the machine's MAC address.
● LINK Status
Displays the current Ethernet speed setting.
❍ 100M Full Duplex
❍ 100M Half Duplex
❍ 10M Full Duplex
❍ 10M Half Duplex
● LINK Setting
Specifies the speed for Ethernet communication. Select a speed that matches your network
environment.
For most networks, the default setting is the optimum setting.
Default: [Auto]
❍ Auto
❍ 100M Full Dup
❍ 100M Half Dup
❍ 10M Full Dup
❍ 10M Half Dup
IP Configuration
● DHCP Activated
Sets the machine to receive its IP address, subnet mask, and default gateway address
automatically from a DHCP server.
When DHCP is used, you cannot specify the IP address, subnet mask, or default gateway
address manually.
Default: [On]
❍ On
❍ Off
● IP Address
Specifies the machine's IP address when DHCP is not used.
Use this menu to check the current IP address when DHCP is used.
Default: 192.0.0.192
● Subnet Mask
Specifies the machine's subnet mask when DHCP is not used.
Use this menu to check the current subnet mask when DHCP is used.
Default: 255.255.255.0
● Gateway
Specifies the machine's default gateway address when DHCP is not used.
Use this menu to check the current default gateway address when DHCP is used.
Default: 192.0.0.192
Contents Previous Next Settings
