Top Page > Maintenance > Cleaning > Cautions to Take When Cleaning
Cautions to Take When Cleaning
● Do not attempt any maintenance or troubleshooting other than that mentioned in this manual. This
machine contains a laser beam generator and direct exposure to laser beams can cause permanent eye
damage.
● The inside of this machine becomes very hot. Do not touch parts labelled “ ” (indicating a hot surface).
● Be sure to disconnect the plug from the wall outlet and clean the prongs and the area around the prongs at
least once a year. Allowing dust to build up on the plug constitutes a fire hazard.
Clean the machine periodically to maintain high print quality.
Dry wipe the exterior with a soft cloth. If dry wiping is not enough, wipe with a soft, damp cloth that is
wrung out well. If you still cannot remove the stain or grime, use a neutral detergent, wipe over the area
with a well-wrung damp cloth, and then dry wipe the area and allow it to dry.
● To avoid deformation, discoloration, or cracking, do not use volatile chemicals, such as benzine and thinner, or spray
insecticide on the machine.
● If there is dust or grime inside the machine, wipe with a clean, dry cloth.
● You must disconnect the plug from the wall outlet at least once a year. Clean away any dust and grime from the plug and
outlet before reconnecting. Accumulated dust and grime pose a fire hazard.
● Do not allow paper clips, staples, or other small objects to fall inside the machine.
Top Previous Next
Copyright © 2009
Contents Previous Next Settings
