Removal and Replacement
TDS 310, TDS 320 & TDS 350 Service Manual
6Ć9
TableĂ6Ć3:ăTools Required for Module Removal (Cont.)
Item
No.
DescriptionName
5 Nut driver, 5/16 inch Used for removing earth ground
cables.
6 Nut driver, 3/16 inch Used for removing GPIB connector
shell and EMI gasket.
7 AngleĆtip tweezers Used for knob and shaft removal.
8 SlipĆJaw Pliers Used for removing the front feet
from the cabinet.
9 Wooden Spudger Used for front EMI gasket removal.
10 Front Cover This optional accessory protects the
front of the oscilloscope when posiĆ
tioned face down in the removal
procedures.
11 Gloves, lint free, cloth Used for removing the menu elastoĆ
mer and menu button flex circuit.
12 Soldering Iron 15 watt. Used for removal of some
cables.
13 Solder Wick
14 BNC Wrench Removing BNCs from the attenuator
assembly. Tektronix 003Ć1463Ć00.
15 BNC Fixture Installing BNCs on the attenuator
assembly. Tektronix 003Ć1464Ć00.
WARNING
To avoid injury or death, unplug the line cord from the line voltage
power source before continuing.
1. Have handy a flatĆbladed screwdriver (Item 4).
2. Set the oscilloscope so its bottom is down on the work surface and its
rear is facing you.
Line Fuse and Line
Cord
