Warranted Characteristics
Specifications
1Ć4
TableĂ1Ć1:ăWarranted Characteristics Ċ Signal Acquisition System (Cont.)
Name Description
Accuracy, Offset Volts/Div Setting
2 mV/div - 99.5 mV/div
100 mV/div - 995 mV/div
1 V/div - 10 V/div
Offset Accuracy
±(0.4% |Net Offset
1
|
+ 3 mV + 0.1 div V/div setĆ
ting)
±(0.4% |Net Offset
1
|
+ 30 mV + 0.1 div V/div setĆ
ting)
±(0.4% |Net Offset
1
|
+ 300 mV + 0.1 div V/div setĆ
ting)
Analog Bandwidth, DC Coupled TDS 310:ĂDC - ≥50 MHz
TDS 320:ĂDC - ≥100 MHz
TDS 350:ĂDC - ≥200 MHz; DC - ≥180 MHz for 2 mV/div
Cross Talk (Channel Isolation) ≥100:1 at 50 MHz with equal Volts/Div settings on each channel
Input Impedance, DCĆCoupled 1MW±1% in parallel with 20 pF ±2.0 pF
Input Voltage, Maximum ±400 V (DC + peak AC); derate at 20 dB/decade above 100 kHz to
13 V peak AC at 3 MHz and above
Lower Frequency Limit, AC Coupled
2
≤10 Hz
1
Net Offset = Offset - (Position × Volts/Div). Net offset is the voltage level at the center of the AĆD converter dynamic range. Offset
Accuracy is the accuracy of this voltage level.
2
The AC Coupled Lower Frequency Limits are reduced by a factor of 10 when 10X, passive probes are used.
TableĂ1Ć2:ăWarranted Characteristics Ċ Time Base System
Name
Description
Accuracy, Long Term Sample Rate
and Delay Time
±100 ppm over any ≥1 ms interval
Accuracy, Delta Time MeasureĆ
ments
1, 2
For singleĆshot acquisitions using sample acquisition mode and a
bandwidth limit setting of FULL:
ąą±(1 WI + 100 ppm |Reading| + 0.6 ns)
For repetitive acquisitions using average acquisition mode with
≥16 averages and a bandwidth limit setting of FULL:
ąą±(1 WI + 100 ppm |Reading| + 0.4 ns)
1
For input signals ≥5 divisions in amplitude and a slew rate of ≥2.0 divisions/ns at the delta time measurement points. Signal must
be acquired at a volts/division setting ≥5 mV/division.
2
The WI (waveform interval) is the time between the samples in the waveform record. Also, see the footnotes for Sample Rate Range
and Equivalent Time or Interpolated Waveform Rates in Table 1Ć11 on page 1Ć12.
