TDS 310, TDS 320 & TDS 350 Service Manual
6Ć7
Removal and Replacement
This section contains procedures for removal and installation of all
mechanical and electrical modules.
WARNING
To avoid injury or death, disconnect the power cord from the line
voltage source before performing any procedure in this section.
General Instructions
READ THESE GENERAL INSTRUCTIONS BEFORE REMOVING A
MODULE.
First locate the module you want to remove in the exploded views
(Figures 10Ć1 through 10Ć3 on pages 10Ć5 through 10Ć9). Then read
Equipment Required for a list of the tools needed to remove and
install modules in this oscilloscope.
To remove an internal module, you need only remove the oscilloĆ
scope cabinet (page 6Ć13) and then perform the removal procedure
for that module. The internal modules are independently removable.
Procedures will refer to front," rear," top," etc. of the oscilloscope;
note from Figure 6Ć1 which sides are referenced.
Preparation Ċ
Please Read
