TDS 310, TDS 320 & TDS 350 Service Manual
7Ć1
Options and Accessories
This section describes the various options as well as the standard and
optional accessories that are available for the TDS 310, TDS 320, and
TDS 350.
Options include the following.
Option 14: I/O Interfaces
This option includes GPIB, RSĆ232, and Centronics interfaces, VGA video
output, and power for the Option 3P printer. It also includes the TDS 310,
320 & 350 Programmer Manual.
You can connect a remote display to the VGA 9Ćpin D connector on the rear
panel. Table 7Ć6 on page 7Ć4 gives the part number of a properly shielded
cable that is commercially available.
Because display manufacturers use different pin combinations and
connectors, you may find the information in Table 7Ć1 helpful.
TableĂ7Ć1:ăVGA Output Connector Pins
Pin
Signal
2 Video (monochrome analog)
4 Horizontal sync @ 31.5 kHz (VGA rate)
5 Vertical sync
6, 7, 8 Ground
Options A1-A5: International Power Cords
Besides the standard North American, 110 V, 60 Hz power cord, Tektronix
ships any of five alternate power cord configurations with the oscilloscope
when ordered by the customer (see Table 7Ć2).
TableĂ7Ć2:ăInternational Power Cords
Option
Power Cord
A1 Universal European Ċ 220 V, 50 Hz
A2 UK Ċ 240 V, 50 Hz
A3 Australian Ċ 240 V, 50 Hz
Options
