A SERVICE OF

logo

Removal and Replacement
TDS 310, TDS 320 & TDS 350 Service Manual
6Ć17
1. Perform the previous procedure to remove the trim ring.
2. Have handy a flatĆbladed screwdriver (Item 4).
3. Set the oscilloscope so its bottom is down on the work surface and its
front is facing you.
4. Insert a flatĆbladed screwdriver into the slot at the frontĆright of the
chassis (see Figure 6Ć8). Push inwards to release the snap lock at the
right side.
5. Lift the front panel assembly out of the front of the main chassis until you
can reach the interconnect cables connecting it to various other modĆ
ules.
6. Unplug the main board and menu flexĆcircuit cables from their jacks on
the front panel assembly.
7. Finally, lift the front panel assembly out of the front of the main chassis
to complete the removal.
Menu Flex
Circuit
Front Panel
Assembly
Press Latch
to Release
Figure 6Ć8:ăFront Panel Assembly and Menu Flex Circuit Removal
Front Panel
Assembly and Menu
Flex Circuit