Removal and Replacement
Maintenance
6Ć24
WARNING
To avoid injury or death, do not unplug the anode from the monitor
when removing or replacing the monitor module.
6. Remove the three TĆ15 Torx® screws securing the monitor assembly to
the top of the chassis. (See Figure 6Ć12 to locate the screws.)
7. Push up on the left top tab lock on the trim ring and pull the left corner
of the trim ring forward slightly.
8. Tilt the rear of the monitor assembly upward slightly. Slide the monitor
assembly back in the main chassis until it stops (about 2 cm). Now lift it
straight up out of the top of the main chassis to complete the removal.
9. While heeding the WARNING on monitor handling that immediately
precedes step 3 of this monitor removal procedure, store the monitor
assembly in a protected location. Place it face down on a soft, nonabraĆ
sive surface to prevent scratching the face plate.
10. Reinstallation: perform steps 8 through 5 in reverse order to reinstall the
monitor assembly.
