Warranted Characteristics
Specifications
1Ć6
TableĂ1Ć4:ăPower Requirements
Name
Description
Source Voltage and Frequency 90 to 132 VAC
RMS
, continuous range, for 47 Hz through 440 Hz
132 to 250 VAC
RMS
, continuous range, for 47 Hz through 63 Hz
Power Consumption ≤65 Watts (120 VA)
TableĂ1Ć5:ăWarranted Characteristics Ċ Environmental, Safety, and Reliability
Name
Description
Atmospherics Temperature:
-10_ C to +55_ C, operating;
-51_ C to +71_ C, nonĆoperating
Relative humidity:
to 95%, at or below +40_ C; to 75%, +41_ C to +55_ C
Altitude:
To 15,000 ft (4570 m), operating;
to 40,000 ft (12190 m), nonĆoperating
Dynamics Random vibration:
0.31 g
RMS
, from 5 to 500 Hz, 10 minutes each axis, operating;
2.46 g
RMS
, from 5 to 500 Hz, 10 minutes each axis,
nonĆoperating
Emissions
1
Meets or exceeds the requirements of the following standards:
EN 50081-1 European Community Requirements
EN 55022 radiated emissions
EN 55022 Class B conducted emissions
EN 60555-2 power harmonics
VFG 0243
FCC Rules and Regulations, 47 CFR, Part 15, Subpart B, Class A
Susceptibility
2
TDS 310 and TDS 320: ≤±0.2 division waveform displacement, or
≤0.4 division increase in pĆp noise.
TDS 350: ≤±0.2 division waveform displacement, or ≤0.4 division
increase in pĆp noise below 200 MHz. ≤±0.3 division waveform disĆ
placement, or ≤±0.6 division increase in pĆp noise from 200 MHz to
500 MHz.
The instruments are subjected to the EMI specified in the following
standards:
EN 50082-1 European Community Requirements
IEC 801-3 radiated susceptibility
IEC 801-4 fast transients
IEC 801-5 AC surge
1
To maintain emission requirements when connecting to the I/O interface of this oscilloscope, use only a highĆquality, doubleĆshielded
(braid and foil) cable. The cable shield must have low impedance connections to both connector housings. The VGA cable must also
have ferrite cores at either end. Acceptable cables are listed in Table 7Ć6 on page 7Ć4.
2
Susceptibility test run with both channel inputs terminated with grounding caps, both channels set to 2 mV/Div, DC Coupling, the
trigger source set to Line, the Acquisition Mode set to Peak Detect, and the time base set to 25 ms/Div.
