Agilent Technologies Agilent 81130A 400 Welding System User Manual


  Open as PDF
of 124
 
18
General Programming Aspects
Common Command Summary
Common Command Summary
This table summarizes the IEEE 488.2 common commands supported by
the Agilent 81130A:
Command Parameter Description
*CLS Clear the status structure
*ESE <0255> Set the Standard Event Status register mask
*ESE? Read the state of the Standard Event Status enable register
*ESR? Read the state of the Standard Event Status event register
*IDN? Read the Instrument's Identification string
*LRN? Read the complete Instrument Setting
*OPC Set the Operation Complete bit when all pending actions
are complete
*OPC? Read the status of the Operation Complete bit
*OPT? Read the installed options
*RCL <04> Recall a complete Instrument Setting from memory
*RST Reset the instrument to standard settings
*SAV <14> Save the complete Instrument Setting to memory
*SRE <0255> Set the Service Request Enable Mask
*SRE? Read the Service Request Enable Mask
*STB? Read the Status Byte
*TRG Trigger
*TST? Execute instruments selftest
*WAI Wait until all pending actions are complete
 previous next