Filter
Top Products
27
Programming Reference
Agilent 81130A SCPI Command Summary
:DIGital
[:STIMulus]
:PATTern
48
:LOOP
45
:INFinite
46
[:STATe]
ON | OFF | 1 | 0 Enables/Disables the infinite loop
:STARt
SEGM1 | SEGM2 |
SEGM3 | SEGM4
Set/read the start of the infinite loop (the
segment to restart the output after the last
bit of the last used segment)
47
[:LEVel[1]]
[:COUNt]
<value> Set/read the segment loop count
:STARt
SEGM1 | SEGM2 |
SEGM3 | SEGM4
Set/read the start segment for the counted
segment loop
47
:LENGth
1 | 2 | 3 | 4 Set/read the number of segments within the
segment loop
48
:PRBS
<base> Set/read the PRBS base (the same for all
PRBS segments!)
48
:SEGMent[1|2|3|4]
:DATA[1|2]
<data> Set/read pattern data
49
:LENGth
<segment-length> Set/read the length of the segment (if the
length is increased, 0 bits are appended)
52
:PRESet[1|2]
[<n>,]<length> Set preset pattern with frequency CLOCK
÷
n
53
:TYPE[1|2]
DATA|
PRBS|HIGH|LOW
Set/read the type of the segment
53
[:STATe]
OFF|ON|0|1 Switch PATTERN pulse-mode on or off
:UPDate
OFF|ON|ONCE Update the hardware with pattern data
54
:SIGNal[1|2]
:FORMat
RZ | R1 | NRZ Set/read data format of output channel
54
Command Parameter Description see page