Filter
Top Products
29
Programming Reference
Agilent 81130A SCPI Command Summary
[:SOURce]
:CORRection[1|2]
:EDELay
60
[:TIMe]
<value> Set/read channel delay deskew
:CURRent[1|2]
The CURRent and VOLTage subsystem can-
not be used at the same time. Use the :HOLD
command to select between them.
60
[:LEVel]
[:IMMediate]
[:AMPLitude]
<value> Set/read channel amplitude current
:OFFSet
<value> Set/read channel offset current
61
:HIGH
<value> Set/read channel high-level current
62
:LOW
<value> Set/read channel low-level current
63
:LIMit
:HIGH
<value> Set/read maximum current limits
63
:LOW
<value> Set/read minimum current limits
64
:STATe
ON|OFF|1|0 Enable/Disable the current limits
64
:FREQency
<value> Set/read frequency of pulses
65
[:CW]
[:FIXed]
:AUTO
ONCE Do a frequency measurement at CLK IN
66
:HOLD[1|2]
VOLT|CURR Switch between VOLTage and CURRent
command subtrees
66
Command Parameter Description see page