Filter
Top Products
102D-Link DIR-505 User Manual
Section 5 - Repeater Mode
LAN Setup
This section will allow you to change the local network settings of the DIR-505. After making your changes, click the Save
Settings button.
Device Name:
LAN
Connection
Type:
Enter the Device Name of the DIR-505. It is recommended
that you change the Device Name if there is more than one
D-Link device in your subnet.
Use the drop-down menu to select the LAN Connection
Type to use.
Select Dynamic IP (DHCP) to automatically obtain an IP
address on the LAN/private network.
Select Static IP Address if all the Internet port’s IP information
is provided to you by your ISP.
IP Address:
Subnet Mask:
Gateway
Address:
Enter the IP address of the access point. The default IP
address is 192.168.0.1. If you change the IP address, once
you click Apply, you will need to enter the new IP address
in your browser to get back into the conguration utility.
Enter the Subnet Mask assigned by your ISP.
Enter the Gateway assigned by your ISP.
If you choose DHCP as your connection type: