Filter
Top Products
127D-Link DIR-505 User Manual
Section 6 - Wi-Fi Hot Spot Mode
System
Save Settings
To Local Hard
Drive:
Load Settings
From Local
Hard Drive:
Restore
to Factory
Default
Settings:
Reboot the
Device:
Remove
Language
Pack:
Clicking the Save button will allow you to save the current
repeater conguration settings to a le on the hard disk of
the computer you are using. You will then see a le dialog
where you can select a location and le name for the settings.
Use this option to load previously saved configuration
settings. Click Browse to nd a previously saved conguration
le. Then, click the Upload Settings button to transfer those
settings to the DIR-505.
This option will restore all conguration settings back to the
factory default settings. Any settings that have not been
saved will be lost, including any rules that you have created.
If you want to save your current conguration settings, use
the Save button above.
Note: Restoring the factory default settings will not reset the
Wi-Fi Protected Status to Not Congured.
Click the Reboot button to reboot the repeater.
If you have previously installed a Language Pack, you can
remove it by clicking the Remove button.
This page allows you to save and restore your conguration, reset and reboot the DIR-505, and remove any added language
packs.