Filter
Top Products
33D-Link DIR-505 User Manual
Section 3 - Router Mode
Select Static IP if your ISP assigned you an IP address, subnet
mask, gateway, and DNS server address. In most cases, select
Dynamic IP.
Enter the IP address (for static PPPoE only).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password
in the next box.
Enter the ISP service name (optional).
Select either Always-on, On-Demand, or Manual.
Enter a maximum idle time during which the Internet
connection is maintained during inactivity. To disable this
feature, set the Reconnect Mode to Always on.
Enter the primary and secondary DNS server addresses
(Static PPPoE only).
If you experience connection issues, you may need to
change the MTU setting for optimal performance with your
specic ISP. 1492 is the default MTU.
Address
Mode:
IP Address:
User Name:
Password:
Service
Name:
Reconnect
Mode:
Maximum
Idle Time:
Primary/
Secondary
DNS Server:
MTU:
If you selected PPPoE, you will see the following settings. Your ISP will provide you with a username and password. This option
is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer
needed and will not work through a router.