Filter
Top Products
118D-Link DIR-505 User Manual
Section 6 - Wi-Fi Hot Spot Mode
Wireless LAN Setup
Use this section to congure the Wireless LAN settings for your D-Link router. This will congure the wireless network you
will connect to with your PCs and devices. You can create a new Wi-Fi network name (SSID) for your local Wi-Fi network
(WLAN), or use the same wireless network name(SSID) as the Wi-Fi hotspot the router is connecting to. After making your
changes, click the Save Settings button.
Local Wi-Fi
Network
Name:
Channel
Width:
Visibility
Status:
Security
Mode:
WPA Mode:
Cipher Type:
Set whether you want to use the same network name as
the Wi-Fi hotspot the router is connected to(Same as Wi-Fi
HotSpot Network Name), or if you want to create a new
network name to use(Create a new Wi-Fi Network Name).
Select whether to use Auto 20/40 MHz or 20 MHz for the
channel width. Normally, this should be left on Auto 20/40
MHz. If you are not using any 802.11n wireless clients, you
can set this to 20 MHz.
This setting controls whether the router’s wireless network
name(SSID) will be broadcast so that wireless devices can
scan for it. If you set it to Invisible, all wireless clients will
need to enter the network name and security settings of
your wireless network manually.
Select from the drop-down menu the type of security mode
you would like to use.
Select Auto, WPA2 Only, or WPA Only. Use Auto if you have
wireless clients using both WPA and WPA2.
Select TKIP and AES, TKIP, or AES.