Filter
Top Products
158
CHAPTER2 Dependence Functions
2.4.3.1 Increasing Communication Speed during Debugging
This section describes setting for increasing the communication speed during
debugging.
■ Standard High-speed Communication
In the case of the emulator debugger (MB2100-01), when the standard high-speed communication is set to
the optimal value, the phase modulation mode is enabled, and high-speed communication can be performed
between the target and adapter. The standard high-speed communication is different in optimal value
depending on the MCU. For details, refer to the Hardware Manual for the product type you are using.
■ How to set
Perform the following method to control the standard high-speed communication.
● Dialog
- [Frequency] tab in debug environment dialog
For details, refer to "4.7.2.3 Debug Environment" in "SOFTUNE Workbench Operation Manual".
● Command
- SET FREQUENCY
For details, refer to "1.45 SET FREQUENCY" in "SOFTUNE Workbench Command Reference
Manual".
Note:
If the frequency is changed during high-speed communication mode, the MCU must be reset. The
frequency is changed after a reset is updated.