Filter
Top Products
52
CHAPTER2 Dependence Functions
2.1.10.2 Setting Trace
You must set the following two items to perform a trace. After that, trace data will be
sampled with the execution of the program. You can set this from the command
window.
■ Setting Trace
1. Enable the trace function
- This is done by [Setup] - [Trace] in the trace window shortcut menu. This program will startup and
will be enabled.
2. Set the trace buffer full break
- When the trace buffer is full, you can make a break. This is done using the setting dialogs of the
trace window shortcut menu [Setup] - [Trace].
- When starting up this program, it is setup for no breaks.