Filter
Top Products
22
CHAPTER1 Basic Functions
1.12 Setting Operating Environment
This section describes the functions for setting the SOFTUNE Workbench operating
environment.
■ Operating Environment
Set the environment variables for SOFTUNE Workbench and some basic items for the workspace.
To set the operating environment, use the [Setup]-[Development] command.
● Environment Variables
Environment variables are variables that are referred to mainly using the language tools activated from
SOFTUNE Workbench. The semantics of an environment variable are displayed in the lower part of the
Setup dialog. However, the semantics are not displayed for environment variables used by tools added
later to SOFTUNE Workbench.
When SOFTUNE Workbench and the language tools are installed in a same directory, it is not especially
necessary to change the environment variable setups.
● Basic setups for workspace
The following setups are possible.
• Open the previous workspace at start up
- When starting SOFTUNE Workbench, it automatically opens the last opened workspace.
• Display options while compiling/assembling
- Compile options or assemble options can be viewed in the Output window.
• Save dialog before closing workspace
- Before closing the workspace, a dialog asking for confirmation of whether or not to save the
workspace to the file is displayed. If this setting is not made, SOFTUNE Workbench automatically
saves the Project without any confirmation message.
• Save dialog before compiling/assembling
- Before compiling/assembling, a dialog asking for confirmation of whether or not to save a source file
that has not been saved is displayed. If this setting is not made, the file is saved automatically before
compile/assemble/make/build.
• Termination message is highlighted at Make/Build
- At Compile, Assemble, Make, or Build, the display color of termination messages (Abort, No Error,
Warning, Error, Fatal error, or Failing During start) can be changed freely by the user.
Note:
Because the environment variables set here are language tools for the SOFTUNE Workbench, the
environment variables set on previous versions of SOFTUNE cannot be used. In particular, add the
set values of [User Include Directory] and [Library Search Directory] to [Tool Options Settings].