Filter
Top Products
199
CHAPTER2 Dependence Functions
2.4.8.3 Searching for Trace Data
This section explains how to search for trace data.
■ Searching for Trace Data
The specified address or frame number in trace data can be displayed.
The following two methods are available to search for trace data: using GUI (window or dialog) and using
only the command. The same result is obtained from both methods.
Using GUI for Searching for Trace Data
1. Display the trace window.
- Select [View] - [Trace] menu.
2. Specify the address or frame number to search for trace data.
- Right-click on the trace window, and select [Find] from the pop-up menu. The trace data search
dialog appears.
Specify the address or frame number to be displayed. For details, refer to Section "4.4.8 Trace" in
"SOFTUNE Workbench Operation Manual".
Using Command for Searching for Trace Data
1. Search for trace data.
- Execute the SEARCH TRACE command.
For details, refer to Section "4.23 SEARCH TRACE" in "SOFTUNE Workbench Command
Reference Manual".
Note:
When specifying the search address, you must specify the head of the instruction, or otherwise
instructions of 2-bytes or longer (LDI:32, and LDI:20 instructions) may not be searched correctly.