Filter
Top Products
41
CHAPTER2 Dependence Functions
2.1.6 Low Power Consumption Mode Simulation
This section describes the low power consumption mode simulation executed.
■ Low Power Consumption Mode Simulation
The MCU enters the low power consumption mode in accordance with the MCU instruction operation
(Write to SLEEP bit or STOP bit of standby control register). Once in the sleep mode or stop mode, a
message ("sleep" for sleep mode, "stop" for stop mode) is displayed on the Status Bar. The loop keeps
running until either an interrupt request is generated, or the [Debug] - [Abort] menu is executed. Each
cycle of the loop increments the count by 1. During this period, I/O port processing can be operated.
Writing to the standby control register using a command is not prohibited.