Filter
Top Products
CHAPTER 2: Setting Up Your Server
12
6 Swing the bezel out 45° from the front of the case, then disengage the tabs on the right
side of the bezel from the chassis and remove it.
7 To reinstall the bezel, align the right side of the bezel with the right side of the chassis at a
45° angle, then insert the three tabs on the right side of the bezel into the slots in the chassis.
8 Swing the left side of the bezel in to the chassis until the three tabs on the left side of the
bezel snap into place.
9 Close the server case by following the instructions in “Closing the server case” on page 26.