Filter
Top Products
www.gateway.com
47
11 Holding the new backplane by the edges only, align it with the locking tabs on the hard
drive cage, then place it on the locking tabs and slide it up.
12 Tighten the thumbscrew to secure the backplane to the hard drive cage.
13 Slide the hard drive cage back into the opening in the front of the chassis until it clicks into
place.
14 Reconnect all cables to the backplane.
15 Replace the system fans by following the instructions in “Replacing system fans” on page 38.
16 Set the chassis upright, if necessary.
17 Follow the instructions in “Closing the server case” on page 26.
18 Reinstall the hot-swap drives back into the server. Make sure that you install the drives into
the same bays you removed them from in Step 4. For instructions see “Removing and
installing a hard drive” on page 29.
19 Replace the bezel by snapping it into place on the front of the server.
Installing and removing a mezzanine board
For information on installing and removing the optional mezzanine board, refer to the Mezzanine
Board User Guide.
Caution
Make sure you do not pinch, bind, or damage any cables as you install the
backplane.
Connect to Mezzanine Board