Filter
Top Products
-40-
Model G0746/G0749 (Mfg. Since 3/13)
Ta il s to c k
Installing Tooling
Using Quill
1. Move the quill lock lever away from the spin-
dle to unlock the quill.
2.
Turn the quill handwheel clockwise to move
the quill toward the spindle or counterclock-
wise to move it away from it.
3.
Move the lock lever toward the spindle to
secure the quill in place.
Figure 48. Example photos of inserting tools into
the tailstock.
Figure 47. Types of tapered arbors and tooling.
Tang
Screw
End
Solid
End
Open
End
Solid
End
Graduated Dial
Increments ................................................. 0.001"
One Full Revolution ...................................0.200"
Increments on Quill
Inch .............................0"–4
3
⁄4" in
1
⁄8" Increments
Metric ................... 0–115mm in 1mm Increments
Positioning Tailstock
1. Pull the tailstock lock lever to unlock the tail-
stock from the bedway.
2.
Slide the tailstock to the desired position.
3.
Push the tailstock lock lever to lock the tail-
stock against the bedway.
The tailstock (see Figure below) is typically used
to support long workpieces by means of a live or
dead center (refer to
Centers
in the following sec-
tion). It can also be used to hold a drill or chuck to
bore holes in the center of a part. Custom arbors
and tapers can also be cut on your lathe by using
the offset tailstock adjustment.
Figure 46. Tailstock and quill lock levers in
locked position.
Quill Lock
Lever
Tailstock Lock
Lever
Quill
Handwheel
This tailstock uses a quill with an MT#5 taper
that accepts tapered arbors and drill bits (see the
Figures below for examples).