Filter
Top Products
WA] ER SUPPLY
Plumbing must comply with local codes It is recommended that a shul-off valve be installed in the line from the
supply to the dishwasher The water supply must be able lo supply a minimum of 9 quarts in one minute Route the
Ime, as shown in Figure 7 (Refer to Figure 5 for permissible routing areas) Do not run it across in front of the motor
Piping must not be kinked The connection to the valve is made with a 3/8" male pipe thread right angle adapter
Assemble the adapter to the valve, using pipe compound or teflon tape, with a wrench on the adapler and a wrench
over the metal bracket enclosing the fitting on the valve If solder connections are used. use care to see that valve
is not overhea!ed CAUTION! Qverheating witl da0qage the valve Clean all ioreign matedal from the pipe and threads
before maldng final connections
IMPORTANT:
TURN ON THE WATER SUPPLY AND CHECK ALL PLUMBING AIqD DISHWASHER CONNECTIONS FOR WATER
LEAKS.
WARNING!
Do not have line pressure Io the water valve in freezing temperatures during construction, remodeling, elc Do not
use the drain hose supplied with the dishwasher for the water supply line It is not a reinforced hose and will burst
under water line pressure
SHUT OFF
VA LV E
HOT WATE
LINE
I
I
\
I
CAUTION
To prevent damage to valve,apply
wrench to hex on valvemetal bracket
and hold securely while installing
rigflt angle adapter,,
ALTERNATE HOT WATER
ENTRY SHOWN BY
DDT_ED LINE
SUPPLY
_REEN GROUND"
SCREW
MOLDED REO EPTACL
/
RIGHT ANGLE ADAPTER -3/8
MALE PIPE THREAD
FIGURE7
12