Filter
Top Products
FLOAT
NORMAL
SWITCH
FIGURE14
2 Testing Water Charge Level
To check for proper water level, pour the minimum charge ol_8 quarts of water into the tub and make a reference
mark with a grease pencil or crayon at the edge of the waterline Then pour in an additional 1Y_,quarts of water
to make the maximum charge, and make another reference line at the edge of the water line, Set the timer to a
portion of the operating cycle for "drain" and allow the drain pump to pump out the water Allow the time to ad-
vance into a )_;fill" period of the operating cycie and allow the normal amount of water to fill the tub After the
water inlet valge has shut off, compare the edge of the water line with the reference marks made above The water
charge must be belween the two lines Remove the marks after completing this test The water level should cover
tile heating element
17