Filter
Top Products
3 Remove power cord reel attach screws exposed on left side of cabinet
Install the replacement power cord reel Wind the reel and cord clockwise to achieve the amount of reel wind-
up needed Coil spring should recoil the power cord comptetety when the cord is fully extended Temporarily
secure the power cord pfug 1o the back side of cabinet and reassemble cord housing and hose guard IHose
guard must be reinstalled )
5 Reptace the top assembly
Casters
Caster Replacement Potlable Dishwashers
Use the following procedure to repair a damaged caster socket Obtain a caster repair kit from your Sears Ser-
vice Department
Drill out the four projection welds that anchor the caster sleeve (See FigureD7) A light tap on the closed end
of the sleeve will dislodge the entire sleeve assembly it is necessary to remove this sleeve so that the new
easter will rest flush on the support cross piece
2 Insert the caster and fasten securely with the nut
CA UTION:
Do not remove the "hat" shaped portion on the frame. This "'hat" will give added stability.
and strength to the caster.
By using this method of replacement, you wnl need to replace only the caster in the damaged socket
This procedure can be followed on most dishwashers Very old units with small diameter wheels require replace-
ment of all four (4) casters
NOTE:
Do not attemp[ to replace casters by merely inserting the new caster m the old sleeve This is not proper and
will cause the machine to be out of level Casters marking the floor can usually be traced to a damaged or
lammed caster assembly This causes the caster 1o shde rather then roff across the floor
DRILL THRU 4 INDENTED WELD *SPOTS ON CASTER
BRACKET & REMOVE SOCKET & WASHER (1/z_ DRILL)
FIGURE87
78