Filter
Top Products
S_EP3
STEP 2 --
S_p4_ _ STEP 1
PLASTIC GUID_ NGE BRACKET
FIGURE76
5
C ARM PIN
Racks
To remove the upper rack only. remove the end caps at the front of the slides by straightening the metal tabs holding
the end caps in place Refer to Figure 77,
END CAP
_" RACK
FIGURE77
To remove the upper racks and slides (square slide out type) proceed as follows
I Detach upper front and lower rear roller on each side (Figure78)
2 Remove racks by raising rack and slides until slides will pass the new rollers (Figure79)
11