Filter
Top Products
CENTER MOTOR SHAFT WITH PUMP HOUSING
WITH SERVICE TOOL 803923--7
/
f
M
3____/
,!' ...... ] ......
10
FIGURE37
SHIM GAUGE 807077_ _
FIGURE38
.,p'--_ RAISE EDGES OF
/
GASKET TO ALLOW
GAUGE TO SEAT ON
PUMP HOUSING
SURFACE
Before repiacqng the required shims and lower impeller on the motor shaft, carefully examine the mating sur-
faces of the lower impeller shaft seal (white ceramic) and the pump housing seal (black carbon) These surfaces
should be perfectly smooth and polished in appearance If either appears scratched, pitted or damaged in any
fashion, the seal must be replaced otherwise a leak may occur
Clean seal cavity thoroughly Install the lower seal. Use service tool 803923.
11 Fasten motor pump housing assembly to tub Be sure casting is clean and a new gasket is used
12. Re-assemble remaining pump components in reverse order of removal
IMPORTANT:
Be sure the relay furnished in the kit is used with the replacement motor, otherwise, serious
damage to the motor can result! Carefully review the instructions packed with the motor
39