Filter
Top Products
PROBLEM
Lever won't latch or
stay in run position.
Detergent Cup won't
latch,
Detergent cup won't
open to release
detergent.
Detergent does not
wash out of detergent
cup.
Wetting agent
tiquid runs out
continuously.
Wetting agent liquid
runs out each time
door is opened and
closed.
POSSIBLE CAUSE
1. Latch lever bent.,
2. Door misaligned to tub.
(Undercounter mode_s.)
1 Cams not locking on linkage arm
(Solenoid operated Cup)_ . ....
2. Cam not locking on bi-metal teaf.
(Bi-metal operated cup.)
3o Roll pin or shaft broken..
4. Broken springs.
1. Roll pin or shaft broken.
2, Cup binding.
3.. Defective solenoid, wiring or timer.
4., Defective bi-metal release, wiring or
timer..
1. Dish or pan blocking detergent cup..
2_ Detergent cup hot and wet when loaded..
3 Old detergent.
Io Wetting agent cup ribs not against
door liner.
2, Diaphragm seal out of shape, puckered,
etCr (Solenoid operated dispenser,,)
3o Springs defective.,
1_ Plunger stuck or held in open position,
2. Coil spring or "C" clip broken,
3., Solenoid defective,
4. Bi*metal release defective..
ACTION
1. Repair or replace mechanism.
2. Loosen attach brackets and reposition
tub for proper door closure,. Be sure
machine is level.
to File notch deeper on surface of cam
that rests against linkage arm.
2. Adjust leaf or replace bi-metat
control.
3, Replace roll pin or install shaft kit,,
4. Replace as needed.
I. Replace roll pin or install shaft kit.
2. Repair or replace as needed..
3. Refer to the wiring diagram and check
detergent cup electHca! circuit.
4. Refer to the wiring diagram and check
detergent cup electricaP circuit..
1. See loading instrUctions in Owner's
Manual.
2. If Cup is wet. dry before loading
3 Don't use detergent that has become
caked or lumpy.
1. Mount cup so all areas of cup ribs are
resting against door liner.,
2_ Replace dispenser
3. Replace springs..
1. Free plunger or adiust bFmetal release.,
2.. Replace parts as necessary.
3.. Replace solenoid and bracket assembly..
4_ Replace bi-metal assmbly.
9O