Filter
Top Products
If the second wash or 'final rinse phase is prolonged for an excessive amount of time, causing the water to become
hotter than necessary:
1. Check for too high calibration,, (Follow same procedure as outlined on the previous page )
2, Check the thermostat circuit for correct wiring
3 Check to see that power is applied to one terminal of thermostat by the timer at the proper time.,
4. Check the heating etemenL
If 1 and 2 are satisfactory, a faulty thermostat is indicated and should be repiacedo
CA U TION:
Care should be taken when installing a replacement thermostat so as not to place any
strain or pressure on the body of the thermostat, Note that the thermostat is held in
position by a clamp on the wire leads,
Some Kenmore Dishwashers, both portable and built-in, are equipped with sensing devices to indicate to the user
the temperature of the water within the machine. The water temperature will fall within the ranges of "Cool,"
"Normal," or "SanY' and wilt be indicated by lights on the console as shown in Figure 59.
TEMPERATURE INDICATOR LIGHT
DRY TIME SELECTOR TEMPERATURE DELAY
FIGURE59
The "coot" thermostat (Figure 60 )is a single pole single throw temperature controlled switch The "sani" thermostat
(Figure 61) is a single pole double throw switch
'SANI'
THER MOSTAT
C©OL THERMOS'fAT
' @ I
)
FIGUREGO
52