Filter
Top Products
DRAIN
Referring to Figures 8 and 9. install the drain connection parts (Y branch tail-piece, disposer adapter, air gap, etc )
in the location selected Instali the drain hose corner support in the corner of the cabinet next to the dishwasher
directly above the 2" access hole The top of the support should be 30" above the kitchen floor 124-' above cabinet
floor)
IMPORTANT:
THE DRA!N LOOP MUST BE FIXED ATA lvl!N,!MUM HEIGHT,,QF,,,32 INCHES BY USE OF A SUITABLE CLAMP OR
SUPPORT._ONE -IYPE OF WHICH IS SHOWN BELOW.
Corner Support Bracket (Furnished
Drain Hose (Furnished)
Entry MUST be
above trap _1_ t
\
Trap P or S
\
"'Branch Tailpie(:
Trap P or S
SINK AT LEFT
3O"Top of Corner Support
Bracket To Floor
2 Access Hole--
FIGURE8
SINK AT RIGHT
Route the hose from the dishwasher cabinet through 1he 2" access hole, then behind the corner support to the drain
and connect Be sure all bends are smooth and the hose is adequately supported The free end of the hose should
extend into the dishwasher cabinet 20" if the hole is on the left side, and32" if the hole is on the right side Cut the
hose to length, being sure cut is square
13