Filter
Top Products
A Removal of Mtddle Spray Arm
1 Remove stainless steeI cotter pin in lower end of plastic spray arm spindle underneath the black plastic supply
arm
2 The spray arm and spindle can now be lifted off the supply arm
Removal of Upper Spray Arm Only
1 From below, in tub, remove two screws which hold spray arm and bearing assembly to plastic distributor
(See Figure 18 )
2 The assembly will then drop loose If il is desired to remove the arm from the bearing assembly, the 1we
screws the1 hold them together are nowraccessibte
NOTE
In Mid- 1980 [he design of the third ,spray arm was changed The spray arm is removed by removing the center
moun_ing screw [See Figure 79]
BEARING
ASSEMBLY
&$
ARM
FIGURE18
;HER
(_ SCREW
FIGURE19
Two Level - Compact Models
The top spray arm water supply system on all 18" (compact) dishwashers is completely external of the wash chamber,
A hose from the back side of the pump housing runs behind the back center of the wash chamber (tub) up to the delivery
tube
To remove: (See Figure 20)
1, Disconnect power supply to dishwasher,
2 Loosenand removeclamp attaching delivery hoseto pump housing /VOTE: Water remaining in hoseand pump should
be caught in a bowl
3 Removefour (4) screws that attach the delivery tube to the tub assembly,
4 Removehose by pulling slowly through the opening in rear of tub.,
Reverseprocedure to reinstalf and check for leaks and kinks,
20