Filter
Top Products
START SWITCH -II'-BLUE-YEL
tr
U_
o
ANY WHITE
POSITION "B"
VOLT METER
RUN WINDING
BLUE -_ORANG
START
RELAY
BLUEoBLACK RINSE WASH START WINDING
BLUE-RED DRAIN START WINDING
WHITE
RED
BLACK
BLUE- RUN WINDING
I _
MAIN MOTOR-REVERSIBLE /3 H,P, 3450 RPM
115V 60HZ AC
FIGURE32
.
Restart. the dishwasher. Voltage at Position "A" indicates voltage to motor-run winding° If the motor does not
"hum," (attempt to start) the run winding isprobably open.A continuity check(power off and coupler separated)
between the blue and white motor lead should indicate low resistance. If an open circuit is indicated, replace
the motor.
3. If no voltage at "A," (Figure 3!), then check for voltage at the output side of timer as shown in Figure 32
Position "B."
4. Continuous voltage at BLU-ORG terminal indicates that timer switch is OK,and the trouble is in the start relay,
wiring, or wiring connections.
If there is no voltage at the BLU-ORG terminal checkfor voltage at the input side of timer,. (Refer to wiring
diagram for the correct timer terminaL)If power is found at the input terminal then the diner is at fault. If
voltage isnot present at input terminat, then problem is somewhere in circuit aheadof timer.. Trace circuit for
causeand make the necessary repairs,.
33