Filter
Top Products
Anti: Tilt Assembly38" Portable Models
A new anti-tilL device was designedfor the 18" dishwasher to prevent overturning with 50 poundssupported on an
open door.
To remove; refer to Figure 75
1. Disconnect power supply
2 Place dishwasher on its back,
3, Remove spring attaching anti-tilt arm to the rear caster bracket.
4. Removecable from anti-tilt arm,,
5 Removescrews attaching foot and shim to the frame assembly
6 Reverseprocedure for replacement.
REAR CASTER BRACKET'
STEP
STEP4
D
SHIM
COUNTERBALANCE ARM-
FIGURE
"C" Arm Replacement ]8 Dishwashers
£RING
NER
I Remove spring and cable from "C" arm (Figure 76)
2 Remove two (2) screws that hoid "C" arm to inner door,
3 Remove bottom two (2) screws holding hinge bracket assembly to wrapper
4 Remove plastic "C" arm guide
5 Remove "C" arm pin from hole in hinge bracket assembty
6 Push "C" arm through the notched area of the tub flange
7 Reverse procedure to replace
7O