Filter
Top Products
TERMINAL
TERMINAL /
TERMINAL " !__"
FIGURE35
G After the Main Motor has been tested and proven good, the motor relay may be checked as follows:
1. Connect the machine to electrical power.
2 Advance the timer to the beginning of a wash or drain cycle,
Set your voltmeter to the 250V, AC scale and connect the leads to terminals "S" and "L" of the starting relay
(Figure 35), Apply power to the machine, If the motor hums and voitage is indicated on th_ meter, the relay
contacts are not closing and the retay must be replaced If the motor does not hum, disconnect the power and
make a continuity check of the retay coif (terminals L to M) before checking the leads and timer
36