Filter
Top Products
Failure of the Bi-Metal to lift can usually be traced to an interruption of its circuit path, which includes the heating
element Therinse injector Bi-Metat isvery similar to that for the detergent cup, and it ischeckedin the same manner,
A voltmeter may beusedin serieswith the Bi-Metal (see Figure 53) to check for an open circuit condition_ Reference
should be made to the proper schematic wiring diagram to locate such a condition
FIGUP,E 53
CA UTION:
Do not apply line voltage across the Bi-Metat as this would destroy it, A voltmeter
across the Bi.Metal terminal will indicate approximately one volt if operation is correct
but a poor connection at the Bi-Metal terminal could show line voltage,
Leaking Wetting Agent Dispenser - Bi-Metal Type
Overfilling the wetting agent dispenser can cause the liquid to be forced past the plunger when the plug is replaced,
This liquid will run down the door between the door and outer panel and may drip to the floor Make sure that the
door of the dishwasher does not open past the horizontal position This may cause the wetting agent to leak out,
This can be corrected by raising the front levelers slightly on undercounter models
48