Filter
Top Products
BOLTS
(4)
FAN HUB
MOUNTING
FOOT
FLYWHEEL
SPLASH
PLATE
FAN
NUT
STATOR / ENGINE
MOUNTING BOLTS &
LOCK WASHERS
BEARING
FIGURE F.26 – STATOR REMOVAL
STATOR/ROTOR REMOVAL AND REPLACEMENT (CONTINUED)
PROCEDURE
First, cut any necessary cable ties in order to free the
stator leads from the bundle of leads running to the
control box. Refer to Figure F.39 for stator removal.
1. Using the 1 1/8" wrench, remove the fan nut.
Remove the fan, noting its direction for reassem-
bly.
2. Using the gear puller, remove the fan hub.
3. Using the 3/8" wrench, remove the two bolts and
flat washers holding the bearing in place.
4. Using two air impact from bottom wrench on top,
remove the nut, lock washer, and carriage bolt
holding the alternator mounting foot to the machine
base. Do this on each side.
5. Using the 3/8" wrench, remove the three bolts from
the flywheel splash plate. Remove the plate.
6. Support the stator with the hoist. Place wooden
blocks under the engine to support it when the sta-
tor is removed.
7. Using the 17mm" wrench, remove the bolts and
lock washers holding the stator to the engine.
8. Remove the stator from the engine. It may be nec-
essary to pry and slide it free.
TROUBLESHOOTING AND REPAIR
F-65 F-65
VANTAGE® 500
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC