Filter
Top Products
F-54
TROUBLESHOOTING & REPAIR
F-54
PROCEDURE
1. Remove input power to the V250-S.
2. Perform
Filter Capacitor Discharge
Procedure
detailed in Maintenance
Section.
3. Locate the input rectifier and the
leads connected to it. See Figure
F.16.
4. Identify and mark the leads connect-
ed to the rectifier terminals.
5. With the Phillips head screwdriver
remove the eight leads connected to
the rectifier terminals.
6. Using the 3/16” Allen wrench and
7/16” box wrench remove the two
cap head screws, washers and nuts
mounting the input rectifier bridge to
the center panel assembly.
INPUT RECTIFIER BRIDGE REMOVAL AND REPLACEMENT (continued)
INVERTEC V250-S
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
#207
#207A
#209
A
B
C
CAP HEAD
MOUNTING
SCREWS
Figure F.16 Input Rectifier Lead Locations